The Wiggle rig is available in different configurations
for both attaching to your line and to a weight
Choose the one that fits your fishing style best
The SpecTastic Lock Swivels
These lock swivels allow for the quick changing of the Spectastic, (it does wear out) No knots are required in the SpecTastic, remember to pull the SpecTastic all the way up in the swivels to lock it. These swivels will cut the SpecTastic at about 7 lbs, but since you never fight the fish against these, (they are below your hook and lure) you can never loose a fish if your weight snags up, and the swivels cuts the SpecTastic.
Make sure you pull the SpecTastic to end of the swivel as shown in the photo above
These lock swivels are used in the Wire Rigs, Finesse, Tear drop, and Snap kits
The Weight Release wire kit
Also the Double Loop kit
This Wiggle rig allows the using of "any" size weight up to about 3/4 Oz
The wire is designed o partially grab everything on the bottom, to allow you to work your lures in one spot, since you need at least 1/2 Oz resistance at the end of the SpecTastic, this wire gets that from grabbing the bottom trash, even when using a very light weight. The wire will not snag you up, it is a light spring steel that comes loose from trash easily,, if the lead snags, the wire will pull out of the weight, saving your rig,, just slip another weight on the wire
The bullet weight shown at the top left, shows the legs of the wire bent forward and up, on one leg and down on the other, this is for clean bottoms , so one wire leg will dig unto the bottom.
To rig this just slide the wire into a weight, bend the legs at 180 degrees from each other, on clean or sandy bottoms bend the ends like on the bullet weight shown above, so the wire will dig into the bottom, Wires can be snipped off after it is bent to hold the weight , if your using enough weight, or you just have a very trashy bottom.
The Wire release kit uses the lock swivels
to attach you fishing line to the SpecTastic
The Double loop kit, just tie your line to the loop
There are a few ways you can rig lures to the Wiggle rig
The standard way is just like a drop shot rig
Tie you hook on leaving a long tag past the knot
then attach the Wiggle rig to the end of your line.
Any hook and any knot works on the hook
If you are using a lure that wants to twist your line,
a swivel can be placed above the hook
You can also keep a lure very close to the bottom sliding the wiggle rig on your line
then tying your hook on the end of your line
Another method of attaching the hook is the Adjust-A-Hook
this little bead allows for the hook to be ajusted, but stays where you
put it, even when fighting a fish,
click image for details on how it works
